Micronics PCI/ISA System Board D6-IN Información técnica descargar pdf (Pagina 25)

Twister LX System Board Manual

Chapter 3: Installing the Twister LX

2. Place the Retention Base over the Slot 1 connector

and insert it down into the Support Bridges with

studs. Note the “Keyed” location of both Slot 1 and

the Retention Base.

3. Using a screwdriver, tighten all four

sides of the Retention Base.

Installing a CPU

Follow the steps below to install the Pentium II processor:

1. Locate the Slot 1 connector (refer to Figure 2-1).

2. If you are installing the boxed version of the Pentium

II processor, follow the instructions in the section

“CPU Installation (Boxed version).”

3. If you are installing the optional Heat Sink Support,

continue to step 4; if not, go to step 5.

Retention Base

Keyed

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 85 86

Twister LX Pentium II 1
Portions of the Manual 2
Trademarks 2
Copyright Notices 2
Table of Contents 3
List of Figures 6
List of Tables 6
Introduction 7
Features 8
Software Compatibility 9
Before You Begin 10
Quick Installation 11
Chapter 1: Quick Installation 12
Configuring the Twister 13
Twister LX System Board 14
Jumper Settings 15
Installing the Twister 19
System Memory 21
Memory Configurations 22
CPU Installation 24
Installing a CPU 25
Retention Base 25
CPU Installation Overview 27
Install to 28
Removing DIMMs 29
The BIOS Setup Utility 33
Figure 4-1: Power-Up Screen 34
Running the Setup Program 35
Date and Time 36
Hard Disks Setup 36
Diskette A or B 37
Base/Extended/Other Memory 37
Virus Warning 38
CPU Internal Cache 38
External Cache 38
Gate A20 Option 40
Typematic Rate Setting 40
Security Option 40
PCI/VGA Palette Snoop 40
OS Select for DRAM>64MB 41
Video BIOS Shadow 41
Chipset Features Setup 42
Power Management 46
PM Control By APM 47
Video OFF Method 47
Video OFF After 47
Modem Use IRQ 47
Doze Mode 47
IRQ 8 Clock Event 49
Reload Global Timer Events 49
PnP OS Installed 50
Resources Controlled By 50
Reset Configuration Data 51
Assigned To 51
PCI IDE Map To 52
Used Memory Base Address 52
Used Memory Length 52
IDE HDD Block Mode 53
USB Keyboard Support 54
KBC Input Clock 54
Onboard FDC Controller 54
UR2 Mode 55
Onboard Parallel Port 55
Parallel Port Mode 55
ECP Mode Use DMA 55
Supervisor Password 56
User Password 56
IDE HDD Auto Detection 57
HDD Low Level Format 58
Save and Exit Setup 59
Exit Without Saving 59
Special Features 61
Ultra DMA/33 IDE 62
Universal Serial Bus (USB) 62
Appendix 63
Environmental Specifications 65
Battery Disposal 66
Technical Support 67
Appendix B: POST Messages 70
Updating the System BIOS 75
Non-Warranty Service 78
FCC Statement 79
Glossary 80

Comentarios a estos manuales

Sin comentarios

Micronics PCI/ISA System Board D6-IN Información técnica Pagina 25

Comentarios a estos manuales