Micronics PCI/ISA System Board D6-IN Especificaciones descargar pdf (Pagina 17)

3-2

Micronics M54Hi-Plus System Board Manual

Installation of the M54Hi-Plus

The installation of the M54Hi-Plus system board depends on the type of case

you use. The M54Hi-Plus is an integrated baby AT size system board and

may be installed into most cases.

Prior to installing the M54Hi-Plus, make sure you have a clear work space

available and adhere to all anti-static precautions.

If you are unfamiliar with installing a system board, Micronics highly

recommends you read the computer user’s manual or contact your dealer’s

technical support department.

Tools Required

Micronics recommends using the following tools to install the M54Hi-Plus:

Small Phillips screwdriver.

Tweezers or a pair of needle-nose pliers.

Tray (to hold loose screws).

Equipment Required

Micronics recommends using the following equipment with the M54Hi-Plus

for a typical configuration:

Chassis with standard hardware.

A high quality power supply capable of providing continuous power

within a 5 volt range, plus or minus 5% (eg. 4.75 to 5.25). A power

filter may be used with a noisy AC power source.

AT compatible keyboard (AT Version).

PS/2 compatible keyboard (PS/2 Version).

Eight ohm speaker.

Standard ribbon cables for internal connections.

Standard power cord (grounded).

CPU heat sink with cooling fan (strongly recommended).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 65 66

Sin comentarios

Micronics PCI/ISA System Board D6-IN Especificaciones Pagina 17