Micronics PCI/ISA System Board D6-IN Manual de usuario descargar pdf (Pagina 20)

3-6

Micronics M6Pi System Board Manual

Installing a CPU

The M6Pi is designed to a variety of Pentium Pro processors. Follow the steps

below to install a processor:

1. Turn off the computer and remove its cover.

2. Locate the ZIF socket illustrated in Figure 2-1.

3. Lift the lever of the socket.

4. Locate pin 1 on the processor and pin 1 on the socket. Gently set the

processor into the socket, making sure pin 1 on the processor and pin 1 on

the socket are aligned.

5. Push the lever down until it locks into place.

6. Make sure the speed selection jumpers are set correctly (Chapter 2).

Warning:

Pentium Pro processors require a heat-sink with a cooling fan. Failure to

provide adequate cooling of the processor may seriously affect system

performance or cause permanent damage to the processor.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Sin comentarios

Micronics PCI/ISA System Board D6-IN Manual de usuario Pagina 20